5
This footswitch controls the looping actions for Loop 1.
Pressing the Loop 1 footswitch at any time will arm Loop 1, illuminating the corresponding red LED
and indicating that Loop 1 is ready to receive Play, Stop, Overdub and Undo commands. Loop 1 is
armed by default upon power up.
If there is no audio recorded on Loop 1, pressing the Loop 1 footswitch will begin recording
immediately. Once the loop is recording, pressing the Loop 1 footswitch again will close the loop
and begin playback.
During playback, pressing the Loop 1 footswitch will open an overdub layer on Loop 1. Once an
overdub is recording, pressing the Loop 1 footswitch again will close that overdub layer and continue
playback. When a loop has been recorded but is stopped, pressing the Loop 1 footswitch will resume
playback from the beginning of the loop.
This footswitch controls the looping actions for Loop 2, and functions the same way as the Loop 1
footswitch (see above).
Quickly pressing the Stop footswitch will stop audio playback on one or both loops, depending on
the Arm/All setting (see below).
Holding down the Stop footswitch for at least two seconds will cause loop audio to be erased from
one or both loops, depending on the Arm/All setting.
Footswitches
Loop 1
Loop 2
Stop
