12
STARTING & USING THE MACHINE
Before operation:
•
Before installing Picote tools, always make sure that the machine is fully turned
off and unplugged.
•
Always round off the sharp edges of the shaft to avoid cuts and to make it easier
to insert the shaft into the tool or for a leader to be used.
•
Check that there is the correct length of flexible shaft (without its plastic casing) at the end of the flexible shaft
and that all screws have been loosened so that the shaft can be easily inserted inside the tool. Position the shaft
inside the tool, as far as it will go, and tighten the screws.
Consult accessory manuals (cutters & grinding chains)
for detailed information.
DO NOT ROTATE THE CABLE IN REVERSE UNDER LOAD!
While in operation:
•
Always lay the machine down horizontally on the floor. During drilling, grinding and cutting processes, always use
a separate vacuum extraction system or run water in the drain to remove dust.
This section contains important safety information. Failure to comply could result in serious injury.
1.
The machine has an operator presence control or ‘OPC’. When the control is not held down, the machine
stops. The machine can also be stopped by pushing the Emergency Stop Button down, rotating the power
gear to “O” or unplugging the machine.
2.
Check the rotational direction of the shaft and the rpm. The rotational direction switch is on the control box
(forward or reverse). The control of the rotational speed is also located on the control box. The rotational
speed increases when the speed control is turned clockwise.
3.
Place the tool inside the pipe.
4.
Turn on the power switch.
5.
Release the Red Emergency Switch Off Button.
6.
The machine starts when the OPC foot pedal is pressed down. Always hold the flexible shaft with both
hands firmly while operating the machine.
7.
Rotating the tool slowly makes it easier to move the tool forward inside the pipe.
8.
The lifespan of the shaft outer casing can be prolonged by using a Sleeve Bearing designed for the outer
casing.
Display messages
There is a display on the frequency transformer. The following messages may occur:
Stop
The Super Midi Miller is ready and waiting for OPC activation
. . . .
The Super Midi Miller is using more current than nominal current (
RED
flashing dots)
E
-
trip
The Super Midi Miller is overloaded to the point that the power will be cut off momentarily. Lift
your foot off the pedal and press the pedal down again to continue. Avoid overloading the motor.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
OPERATING INSTRUCTIONS
12
Picote Solutions Oy Ltd www.picoteinstitute.com
