SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
REPAIRING A DAMAGED CABLE
-
HANDLE END
4. Take out the bearing and unscrew the handle from the outer casing
5. Carefully cut the outer casing. Avoid
cutting the wire inside. Cut at least 25mm
(1”)
or until there is no damaged wire left.
6. Pull the wire at the Jaw end and trim the
inner casing to the same length as the outer
casing. Approximately 5mm
(0.2”)
of the
inner casing should be showing.
7. Push the wire back in and screw the handle back on to the outer casing. A vice helps hold it in
place.
10
14
Picote Solutions Oy Ltd www.picoteinstitute.com
