Picomed NaturalPoint SmartNav 4, Manual

Page: 33 / 43

2. Check all connections. Unplug and securely reattach all male-female connections.
3. Go to the Tracking tab and move a dot back and forth 2' in front of the SmartNav device and check to
ensure that the yellow dot in the data window is green. If so, keep moving dot and try switch clicking
again.
4. Unplug switches and breakout cable. Shut down software. Reattach switches and breakout cable. Run
software.
9.6 Problem : When using the Dwell Clicking feature, the system clicks faster/slower than I would like.
Possible Cause
Dwell Click speed set too fast/slow.
Solution
On the Dwell Click toolbar, click on the setting box. (Hammer & wrench). Click on the Dwell tab. Adjust
the slider bar marked Click Time (Seconds). This will be saved as your new Dwell Click speed.
9.7 Problem : When using the Gravity feature, the cursor locks onto undesired icons or does not lock onto desired
icons.
Possible Cause
Wrong icons selected for Gravity feature.
Solution
Click on the Gravity tab. Uncheck the boxes next to the icons that you do not want the cursor to lock onto.
9.8 Problem : None of the speed settings for Ring/Dot feel right.
Possible Cause
Incorrect speed settings.
Solution
Click on the Movement tab. Adjust the speed slider bars. Move these bars to the left for slower speeds and
to the right for faster speeds.
9.9 Problem : In Dot mode the unit stops tracking me when I move the cursor towards the edges of the screen.
Possible Causes
1. Incorrect speed setting.
2. Improper unit placement.
3. Too much distance between the user and SmartNav unit.
Solution
1. Select the next highest speed setting.
2. Click the Tracking tab on the SmartNav software screen. You should see one green dot in the Data
NaturalPoint SmartNAV Users Manual : Getting Started 07/03/2008 03:35:45 PM
32/41