Picogram PnP Plug&Play, User Manual

Page: 10 / 14

-10-
5.4 Installation of the head connector assay
Install in the convenient area under a sink to be apart more than 30cm (1ft) from the floor.
If installed lower, it will not be possible to install the filter. (Refer to Fig. 6)
5.5 Filter installation
Caution: Install the filter according to the procedure marked in the connector of the
head connector assay. If the procedure is changed, it may cause
a serious problem with the purification performance.
5.5.1 Twist Type
1. Arrange the filter as shown in Fig.7 and insert the filter. Push it up and insert by
turing 90
°
clockwise.
5.5.2 Push Type
1. Arrange the filter in the hole of the lower part of the connector and then push it up
and insert by turning the filter.
(For Push type, if
‘
Click
’
sounds, it means that it has been installed normally.)
2. Check to make sure that the push button is coming out normally.
(If it is not coming out, it means that the filter is not completely installed.)
Fig. 6. Attachment of the head Fig. 7-1 Installation of the Fig. 7-2 Installation of the Turn
connector assay Twist type filter type filter
②
insert the
filter and
then
turn 90
°
clockwise.
①
match the direction of the
filter and connector as
shown in the figure.
insert the
filter into the
connector.