PICOBREW Z SERIES
| 29
12.
Insert the Drain Tube into the Drain Tube Grommet and
then fit the assembled Drain Tube into the Drain Tube
hole in the Step Filter Lid. Make sure that the Drain Tube
is aligned with the Step Filter Drain.
13.
Place lid onto step filter, making sure that the drain tube
is in the normal back-right position.
14.
Fill your keg with 1.74 gallons (14.5 lbs) of water. Use
a gallon jug and measuring cup or a scale to measure
your water. (1 US gallon of water = 8.34 lbs.) If you use
a scale to measure your water, don’t forget to tare it
to your container before adding water! Accurate water
measurement is important to ensure the best results for
your brew.
15.
Place the Keg Cozy around your keg.
16.
Insert the black Keg Seal, by inserting one end and firmly
pressing around the edge of the seal until it has been
pushed into place. Use caution as the edges of the keg
opening may be sharp.
17.
Slide the step filter into your Z, making sure that it is
completely pushed in on both sides.
18.
Connect the BLACK Ball Lock Fitting to the OUT keg post
and the GRAY Ball Lock Fitting to the IN keg post of your
keg.
19.
Select ‘Start Now’
20.
While your Z brews, you can watch its progress online.
Log in to your picobrew.com account, select the
BrewHouse tab. Look for ‘Now Brewing’ in your sessions.
21.
Once your brew is finished and you have drained it fully
into the fermenting keg, add 0.12 gallons (1 lb) (slightly
less than 2 cups) of water directly into the keg, while the
wort is still hot.
