PICOBREW Z SERIES
fIRSt RInSE | 19
Step filter set-up:
01.
Ensure that the Step Filter Keyhole Plug is securely in
place.
02.
Insert the Drain Tube and Drain Tube Grommet into the
Step Filter Lid as shown in the ‘Assembling the Step Filter’
illustration above.
03.
Place the Step Filter Lid on top of the Step Filter, ensuring
that the holes are aligned correctly.
04.
Slide Step Filter into Z. There should be a little resistance
as the drain slides into place and the Step Filter presses
against the back of the Z. Ensure that both the left and
right sides of the Step Filter are pushed in completely.
Rinse set-up:
01.
Fill your keg with approximately 2 gallons of clean, hot tap
water. Place the keg either on the floor or on the counter
next to your Z.
02.
Connect the BLACK Ball Lock Fitting to the keg post
labeled OUT. Lift the outer ring of the Ball Lock Fitting,
place it on the appropriate keg post, press down firmly
then let go of the outer ring. The Ball Lock Fitting will click
when it fits into place.
03.
In the same manner, attach a Keg Wand to the GRAY Ball
Lock Fitting. Allow the gray hose to hang into an empty 5
gallon bucket.
04.
Power on your Z. From the main menu, select Utilities,
then select Rinse by clicking the Control Knob. Follow the
on-screen instructions.
