PICHLER Kunststofftechnik GmbH
manuel dosing (hand dosing function)
select the menu customer, than manuell dosing.
Confirm with the button
.
„OK“
(pic.8)
Push the button pH or chlorine
and confirm with
again.
„on“
„OK“
.
(pic.9)
The dosing pump will turn in right direction for 10 seconds after than
will automaticly stop. (First time need depend the length of the
chemical tube 30 seconds before the chemical goes into the water).
Application:
If you fill the spa with new water, you can help with manuell dosing to
get the optimal value more fast.
The decent of pH value and this is the
,
optimale carbon hardness
(4 german hardness).
40ppm
How long that the unit need for time until get this optimal value depends
the houshold water hardness.
Usually after 3 days the pH level should be on 7.2 or 7.3 ph and hardness
40ppm.
is not necessary to dosing manuell.
Chlorine
„
“
▲
„
“
▼
manuell dosing
ph off
chlorine
pic.9
pic.8
electrode calibration
Close both water tap, so can avoid water come out of the measure cell
Screw out the electrodes pH and Redox/ORP.
And put the electrodes for 5-10 minute into the calibration container.
(red and yellow marker)
Die BNC-connector must connected during the 5-10 minutes.
After this while of 5-10 minutes should be calibrate pH and redox
Choose the menu customer
„calibrate“
(Bild 10)
Go with the curser up to the ph and push 2 times the ok button.
So act ph must show in the display 7.0 and calib also 7.0 pH.
If you also calibrate redox, please do the same way.
After the calibration screw the pH and redox electrode into the
measure cell tight.
Don‘t forget to open both water taps !
Now the start delay will turn on and start the countdown from 30min.
The unit will start the job after the 30 minutes is gone.
pic.10
menu customer
more settings
settings
manuell dosing
back
calibrate
print off
pic.11
calibrate
redox
ph
back
reset selection
act calib diag
7.0 7.0 0.0
420 420 0.0
page 5 to 7
2017/09
settings
more settings
manuell dosing
back
calibrate
print off
menu customer
back
off