PICHLER Kunststofftechnik GmbH
date and time adjustment
go to more settings
than go with curser to „date or time“.
(pic 2)
Use for adjusting these buttons
.
„OK“
Now you can select with the 3 buttons the time or date.
Confirm if finish with the „OK“ button.
„
“
▲
„
“
▼
pic.2
more settings
time 11:37
dosing alert
back
CL -/+ ------0------
date 01.09.17
i
Now you can select and adjust the border of alert.
decent or climb the selected value, will get a alert and the
LED lamp on the screen will flashing red light.
Suggested adjust values are
.
(pic 3,4)
You can also set alert „OFF“ if you don‘t want it.
pic.2
dosing alert
alert pH
alert redox
back
pic.3
alert pH
smaller
delay (min.)
back
bigger
8.0
6.3
15
alert on
pic.4
alert redox
smaller
delay (min.)
back
bigger
850
450
15
alert on
pic.5
start delay
(picture 5)
factory setting for the dosing activate is
30 min.
If you have a malifunction in your house current, or you connect it
on/off, will start at first the start delay, and you must wait for dosing
is active this setting time.
Same is when the circulation pump stopped.
The electrodes ph and redox need this time to make the correct voltage
on the end top.
This is important for well funktion of dosing.
page 4 to 7
2017/09
delay (min)
30
dosing alert
Press to select and adjust the minimum and maximum alert values
„alert pH“ or „alert redox“.
than you show min./max. border.
(pic. 2)
fine tuning if to much or less clorine in the water
You can test it with test strips before. If to much chlorine in the water
you can set as example CL -2, so the chlorine level will decend about
0,5 mg. And also it is working in the
direction. You can move with the
+
„x“ to the right side position to get more chlorine into the water.
pic.6
more settings
time 11:37
dosing alert
back
CL -2 ---x-0-----
date 01.09.17
delay (min)
30
more settings
time 11:37
dosing alert
back
CL -/+ ------0------
date 01.09.17
delay (min)
30