control panel
PICHLER Kunststofftechnik GmbH
Following picture shown the control panel from the dosing system. You get a overview for apart buttons.
Some of them you need it from beginning to start the dosing system. Declarations for the using
and programming as following sections.
LCD - screen
Programming buttons
The LCD - Screen
On the LCD screen, you see the actually operating status from the dosing unit.
Aditional will shown alert- and fault reports.
Also can show the adjusting data in programming mode.
The screen can show 8 lines finaly.
If are further lines outside the LCD screen, will be shown as a arrow symbole on the
side.
Status LED for ORP
(Redox)
status LED for pH
Status SMD-LED (RGB) screen
The SMD LED lamps provide you quick view status-report (operating report).
If a measure value over or under, will flashing the this status LED (as example color „red“).
Also when already a electrode was calibrated, and the quality of electrode is not good as well,
the LED status light is flashing in the color
„yellow“.
After 30 passed, and the electrode is not replaced the flash lighting changed to the color
„red“.
If the LED lights shows the color „green“
for pH and Redox, the unit is working well.
page 2 to 7
flow activity gauge
(aktiv/inaktiv circulation pump)
start delay time counter
(waiting time until the unit is
activ again)
status-gauge
(date, weekday,
time)
2017/09