Picard PO-3-20S, Owner'S Manual

Page: 46 / 55

Owner’s Manual
PO-3-20S 46 Revision 0
9. Inspect the elongation of the #35 and #40 chains
Inspect the chains using a chain wear gauge. Replace if needed.
10. Check the sprocket for proper chain alignment and wear.
Adjust as needed and verify the proper tension of the benders springs
11 Verify the main conveyor spring elongation
The default length is 3-1/8’’, adjust if needed.
Do not remove the tension completely even if it removes all the noises.
12. Change every roller on the main conveyor
1. Remove the snap ring.
2.Remove the roller and keep the washer.
3. Insert the new roller, then the washer and finally the snap ring.
4. Repeat for the 51 others.