PIAGGIO Liberty 125, Workshop Manual, Page: 86 / 212

- Loosen the clamp and remove the carburettor
from the manifold.
-Remove the complete manifold acting on the 2
retainers as shown in the figure.
- Remove the 2 self threading screws, left and right
and the lateral base retaining screw on the crank-
case base.
- Take off the housings.
- Remove the gasket seal of the housing on the
head.
N.B.
IF THE FLYWHEEL HOUSING IS NOT REMOVED, IT IS AL-
SO NECESSARY TO REMOVE THE TWO KNOB SCREWS.
On the vehicles equipped with the engines mentioned if they are losing a full circle at full gas, we suggest
to intervene on the vacuum socket inserting on the inlet manifold widening the hole from 0.4 mm to 1.5
mm. Remember that such operation must have performed on a disassembled manifold which must be
cleaned afterwards.
Cooling fan
- Refit the parts in reverse order of the removal
operation.
- Make sure that there are spacers with the two
rear retainers of the housing.
- The long spacers should be in a high position.
CAUTION
TAKE CARE TO CORRECTLY POSITION THE FLYWHEEL
CONNECTOR.
- Remove the cooling fan by acting on the three
fixings indicated in the figure.
Engine
Liberty 125 - 200 4tempi
ENG - 86