Manual POWM01 / POWM02 / POWM03 / POWM04
MA 1273-A007 EN
24
Push the module card carefully into the guide rail until the rear contacts the housing’s
frame of the
phy
MOTION
TM
.
Connect the POWM01 or POWM03 module with the connector (2x10 pins, ribbon cable) to
the MCM01 on the rear side.
In the last few millimetres the module’s plug has to match with the backplane’s socket. You
should be able to push in the module with light pressure. In case you experience problems
move the module’s front plate slightly to the left and to the right while pushing in the
module, so that the plug’s pins can slide into the backplane’s socket.
As soon as the module’s front plate contacts the housing’s frame the module is integrated
properly and can be fixed with two electro-conductive bolts.
Now you can start with the electrical installation.
