Manual DIOM01
MA 1271-A003 EN
18
6 Commissioning
Please read the manual for basic commissioning information of the DIOM01/DIOM0a
module :
Further manual
Detailed information on this subject is in a supporting manual:
“
phy
MOTION
TM
Modular Multi-axis Controller for Stepper Motors”
The programming environment
phy
LOGIC
TM
ToolBox is explained in the following manual:
Further manual
Detailed information on this subject is in a supporting manual::
“
phy
LOGIC
TM
ToolBox – Communication Software for the
phy
MOTION
TM
Stepper Motor Controller“
For programming the sequential program please read:
Further manual
Detailed information on this subject is in a supporting manual:
“
phy
LOGIC
TM
Command Reference for the
phy
MOTION
TM
Controller”
i
CAUTION – Possible damage!
Some modules are set to a default value on delivery. So, e.g., the motor
current must be set to the corresponding value (see the motor data from
the motor manufacturer). Connected components like motors can be
damaged by incorrectly set values.
- Please check before starting, if the parameters are correct.
