phyCARD-M
Quick Start Instructions
The serial communication program was configured during the setup with
the following configuration:
115200 baud, 1 start bit, 8 data bits, 1 stop bit, no parity, no flow control.
2.5
Connecting the Host with the Target
In this section you will learn how to connect your host PC with the target.
The connection will be done using a cross-over Ethernet cable and a serial
one-to-one cable. You will start Linux from flash on the target, and you
will be able to login with the serial communication program Microcom as
well as via a Telnet session using a peer-to-peer network connection.
•
Connect the serial cable with the UART1 (connector P1) port on the
target and the first serial interface on your host.
Ensure to use the one-to-one serial cable included in this
Rapid Development Kit.
•
Connect the cross-over Ethernet cable with the connector Ethernet on
the target and the appropriate network card of your host.
•
Click the
Microcom
icon on your desktop.
•
Connect the AC adapter with the power supply connector PWR (12V)
on your board.
After connecting the board with the power supply, the target starts booting.
When the target has finished loading the system, you should see a screen
similar to the following:
30
© 2010 PHYTEC Messtechnik GmbH L-746e_1
