MAGNA
Liquid Crystal
1. INSTALL
1.1 PRINTER SET-UP
Once you reach this stage, LC Magna should
already be in position on a secure appropriate
bench, ready for use.
1.
Take the power cable and align plug to Magna’s
power socket as shown in the photo. Push the
plug in, and twist 90 degrees clockwise until it
clicks. Then, connect the power cable to a wall
socket.
2. At this stage you can also prepare the printer
for internet connectivity.
2.1 To prepare to connect to Wi-Fi: Place the
supplied Wi-Fi dongle into the rear USB port
of Magna.
2.2 To prepare to connect to Ethernet: Connect
one end of an ethernet cable (R45J) to the
socket with the other end connected to your
local area network.
Figure 3&4:
initial set up of Magna power chord
Figure 6: Ethernet cable set-up – pre connection
Figure 5: Wi-Fi dongle set-up – pre connection
UNPLUGGING LC MAGNA:
First switch off the power at the mains, leave for
10-15 seconds for full discharge. Then unplug from
the mains socket and remove the power cord from
the printer itself.
Summary of Contents for Liquid Crystal MAGNA
Page 1: ...LC MAGNA USER MANUAL ...
Page 2: ......
