![background image](http://html1.mh-extra.com/html/phonic/sonic-station-16/sonic-station-16_user-manual_1552847008.webp)
8
sonic station 16
11. 2T rTN
The first of these inputs accommodates RCA cables from such
devices as tape and CD players. in addition to these inputs,
however, Phonic has incorporated a mini stereo port for the
inclusion of mini disc (MD), portable CD, and MP3 players
(such as the Apple iPod), as well as laptop computers.
12. record Outputs with Trim Control
As with the Tape in ports, these outputs will accommodate
RCA cables, able to be fed to a variety of recording devices.
Also included are mini stereo ports for the addition of recording
devices such as MD players and laptop computers. The
Record out also features a convenient trim control, allowing
for simple level matching while recording.
13. Mono / Subwoofer Output
This xlR and 1/4" TRs output feeds a monaural signal of the
Main l-R signals combined, as adjusted by the accompanying
level control. This is ideal for use with a mono sound system, or
for the addition of a subwoofer to your set of speakers, adding
more punch to low frequency sounds. Also featured is an
insert point, allowing external devices, such as a compressor,
to be used to alter the mono signal before it is fed through the
outputs.
The low Pass Filter controls are used to cut unwanted high
frequency sounds of the mono output at a rate of 12 dB per
octave, for a clearer bass sound when using subwoofers,
The switch turns the low Pass Filter on and off, whereas the
accompanying control adjusts the high cut frequency between
60 and 160hz.
14. Main Outputs
These outputs will output the final stereo line level signal
sent from the main mixing bus. The primary purpose of the
two male xlR jacks is to send the main output to external
devices, which may include power amplifiers (and in-turn, a
pair of speakers), other mixers, as well as a wide range of
other possible signal processors (equalizers, crossovers,
etcetera). The two 1/4" TRs phone jacks are able to send
the Main output to external devices that may run in parallel
with the mixer, This may include additional power amplifiers,
mixers, PA systems, as well as a wide range of other possible
signal processors.
15. Main Inserts
located above each of the Main 1/4" outputs, the primary use
for these 1/4" TRs phone jacks is for the addition of external
devices, such as dynamic processors or equalizers, to Main
l and Main R signals. This will require a Y cord that can
send(pre-fader) and receive signals of the mixer to and from
an external processor.
16. Power Connector and Fuse Holder
This port is for the addition of a power cable and supply,
allowing power to be supplied to the mixer. Please use the
power cable that is included with this mixer only. The Fuse
holder, located above the AC Power connector, is, of course,
for the sonic station 16’s fuse. if the fuse happens to blow,
open the holder cover, and replace the fuse with a suitable
replacement (as indicated underneath the power connector).
Main Mixing Panel
17. 12v lamp
This BnC socket allows you to attach a 12 volt gooseneck
lamp, allowing better visibility in areas with poor light.
18. Phones Output
This output port is best suited for use with headphones,
allowing monitoring of the mixer. The audio level of this output
is controlled using the Phones control on the front panel's
master section.
CONTrOlS AND SETTINGS
rear Panel
19. Power Switch
This switch is used to turn the mixer on and off. ensure you
turn all level controls down before activating.
Summary of Contents for Sonic Station 16
