3
POWERPOD 1062 PLUS / 1062R / 1062FR / 1082 PLUS / 1082R
English
10. Main Outputs
These jacks will output the final stereo line level signal sent from
the main mixing bus. The primary purpose of these jacks is to send
the Main output to external devices that may run in parallel with
the mixer. This may include additional power amplifiers, mixers,
Pa systems, as well as a wide range of other possible signal
processors.
11. Power Amp Inputs
These inputs support 1/4" TS plugs and can be used for the
inclusion of an external line level stereo signals to the built-in
power amplifier. If a device is connected to the power amp inputs,
the main feed will automatically bypass the power amp and the
inserted feed will be amplified and sent to the Speaker Outputs
instead.
Rear Panel
12. Speaker Outputs
These jacks are used to connect to speakers, fed from the internal
power amp. On all models, they consist of 1/4" Phone Jacks. The
amp Select switch determines the operation of these jacks. If the
amp Select switch is set to "Main l-R (Stereo)" or "Main / Moni" a
single speaker with a 4 to 8 ohm load can be connected to jack a
on both the left and right Speaker Outputs. You can also connect
two speakers with impedances between 8 and 16 ohms to both
jacks a and B of the left and right Speaker Outputs.
NB.
Due to the fact that the signal has been processed by the power amp,
these ports should be used in conjunction with passive speakers only to
avoid damaging any other equipment.
SPEAKER SETUP
Using speakers with an incorrect loading can not only cause
distortion, but also irreversible damage to the powered mixer.
Please ensure the loadings of your speakers are consistent
with those shown above.
7
9
10
11
8
12
CONTROLS AND SETTINGS
Rear Panel
13. Power Button and AC Connector
The power button, located on the rear of the mixer, is used to
activate the mixer. Of course, there’s no point in activating the
mixer if there’s no power, therefore an ac connector has been
included to ensure your Mixer gets the power it needs. Please use
the power cable that is included with this mixer only.
NB.
Before connecting the ac cable to the Powerpod Mixer, please ensure
the local voltage levels are identical to those chosen by the Voltage Selector
switch.
14. Voltage Selector
This switch allows you to select from 2 mains power modes, 115
Vac / 60 Hz (allowing you to use the device in countries with
voltages between 100V and 120V) or 230 Vac / 50 Hz (allowing
you to use the device in countries with voltages between 220V and
240V). To change the Voltage Selector, you must first unscrew and
remove the plastic cover that protects the switch. after changing
the Voltage, please replace the plastic cover to ensure the voltage
level is not inadvertently altered.
NB.
Using incorrect voltages can cause irreversible damage to the mixer.
all care must be taken in selecting the voltage appropriate to your zone. If
unsure of local voltage levels, contact a knowledgeable source before using
this mixer.
14
13
Summary of Contents for Powerpod 1062 Plus
Page 14: ...10 POWERPOD 1062 PLUS 1062R 1062FR 1082 PLUS 1082R Espa ol...
Page 30: ......
