Phonetics Sensaphone 800, User Manual

Page: 95 / 136

6.2.4 Battery Condition
During a Status Report, you may hear one of three possible
messages regarding battery power. The Model 800 determines the
appropriate message by measuring battery voltage. Depending
upon the remaining voltage, it may respond:
•
“The batteries are OK,”
if over 8.2 Volts.
•
“The batteries are low,”
if between 7.2 and 8.2 Volts.
•
“Replace batteries,”
if below 7.2 Volts.
6.2.5 Remote Access by Touch-Tone™ Telephone
You can issue a number of commands to the 800 remotely using
a Touch-Tone
™
telephone. This command mode can be entered
at any time during the status report. Simply press a Touch-Tone
™
and the unit will halt the report and respond with “OK.” You are
now in Touch-Tone
™
command mode. Commands are available
to perform the following functions:
• Enable and disable zones, power monitoring, and sound
monitoring
• Recite/Set High and Low alarm limits
• Recite/Set telephone numbers
• Record/Play custom voice messages
• Recite/Set the relay output
• Activate the microphone for listen-in
• Recite status report
NOTE
: If a security code is enabled, the 800
will prompt you with “Enter security code.”
Enter the four-digit keypad security code plus
“ # ” to enter touch-tone command mode. If
entered correctly, the 800 will respond with
“OK” and you can proceed to enter the com-
mands. If entered incorrectly, the unit will give
you one more chance. If it is incorrect a second
time, the unit will say “Error, goodbye” and
hang up.
Chapter 6: Acknowledgment, Status Report & Remote Access
92