VIVID SLIMLINE FLOOR MOUNTED BATH MIXER
INSTALLATION INSTRUCTIONS
19mm Particle
board spacer
Floor joist
Floor board
Option B
6
3
PVC Tube
Copper or flexible hose
with G 1/2” Female
connectors.
135 SQUARE
(APPROX.)
100mm
deep
1
Recommended pit to be cast in concrete.
Option A
8
9
For minor adjustment, rotate and adjust
the Mixer Assembly to desired position.
Fasten the Grub Screw to secure the
Mixer Assembly.
Push Down the Cover Plate over the
Mount Plate gently.
www.phoenixtapware.com.au
FLOOR MOUNTED BATH MIXER
IN0162_revA
7
Grub Screw
SAFETY WARNING
Do not use the spout to support yourself when
entering or exiting the bath. Excessive force
may cause the spout to break away from the
body and is not covered by warranty
Connect hot and cold
hoses to the Inlet Body
G 1/2” inlet connectors.
Tighten firmly.
2
4
5b
5a
Fasten Inlet Body to Mount
Plate with 4 x M8 counter-
sunk screws.
Tighten firmly.
x2
TEST AND CHECK
FOR LEAKS
Place Protective Cover over
Inlet Body and fasten with 4
x M8 screws provided.
Tile up to
Protective Cover
REMOVE PROTECTIVE
COVER FROM TILED
FLOOR.
Gently slide Dress Cover
up Mixer Body.
Screw Mounting Flange into
Mixer Body. Tighten firmly.
Use Special Spanner
provided to tighten M15
connectors to Inlet Body
Use M8 screws to secure
Floor Mixer to Inlet Body.
Tighten Firmly.
Locate Mounting Plate
over cast pit and
secure with M10
Dynabolts provided.
Tighten firmly.
Ensure Inlet hoses are
fed through opening in
the Mounting Plate.
FEED HOSES
THROUGH
OPENING
Dress Cover
Mounting Plate
Inlet Body
M15 Connectors
Timber Floor Installation
Copper or flexible hose
with G 1/2” Female
connectors.
WATER SUPPLY REQUIREMENTS
Maximum hot water
temperature
75
550 KPa Max.
150 KPa Min.
Recommended Working
Pressure
Note:
-If the pressure exceeds or is likely to exceed 550kpa,
an approved pressure limiting device must be
installed.
- Flush out all pipe work prior to installation.
- If the water temperature exceeds 75
°
C, an approved
tempering valve must be fitted.
- Installation should comply with Australian standard
AS3500.1 or relevant local authority requirements.
Failure to comply with the above may void all
warranties.
Maintenance and Care
-Chrome plated surfaces should be cleaned with mild
liquid detergent or soap and water.
-
Do not
use cream cleaners or citrus based cleaning
products, as they are abrasive.
-Use of unsuitable cleaning agents may damage the
surface. Any damage caused in this way will not be
covered by warranty.
Installation Instructions
Use M15 Brass
Inserts supplied for
testing.
