![background image](http://html.mh-extra.com/html/phoenix/advanced-pressure-monitor-ii/advanced-pressure-monitor-ii_installation-manual_1551260007.webp)
Advanced Pressure Monitor II Rough-In Installation
Installation Overview
3
MKT-0262 MPC-1748 Rev 02/13
APM2 Rough-In Installation Guide
Figure 1-1.
Wall Mount Installation Overview
1.3.1 Wiring Recommendations
•
All circuits must conform to the requirements of an NEC Class 2 (dry) circuit.
•
Use multiple transformers instead of larger transformers when more than 100 VA is required.
•
Each pressurization zone should have either a dedicated single-phase primary circuit, or a secondary circuit
disconnect.
•
Refer to
Phoenix Recommended Cables on page 33
for approved cable manufacturers and wire types.
•
Use stranded wire for ease of installation.
•
Follow good wiring practices:
• Locate cables away from sources of electrical interference (EMI/RFI).
• Do not run signal or communication cable in the same conduit or wire way as power cables.
• If signal cable must cross power cables place these at a 90-degree angle.
• Shield or drain wires, if required, should be wrapped with insulating tape to prevent contact with exposed
conductors or contacts.
• Maintain a consistent color code or polarity all the way through the wiring system.
• Power supply and signal isolation on I/O devices vary from manufacturer to manufacturer. Verify the
wiring device manufacturer’s recommendations for isolating power and signal common connections and
maintain polarity.
• Local and national electrical codes take precedence.
Single G
a
ng
Electric
a
l Box
1/4" x .170 T
u
be B
a
rb
(Cond
u
it between
s
en
s
or
s
a
nd monitor
p
a
nel m
a
y be req
u
ired.)
Reference
Pre
ssu
re Pick
u
p
Room
Pre
ssu
re Pick
u
p
APM2
NOTE: Connecting tubing and electrical
boxes are field-supplied.
Triple G
a
ng Do
u
ble Deep
Electric
a
l Box
APM2 Faceplate
APM2
Rough-in Electrical Box
- Raco 697
- Appleton M3-350
Electrical Box
Mounting Hole
WALL MOUNT DIMENSIONS
Triple gang dou
b
le deep electrical
b
ox—5.625" (220 mm) W x 3.5" (114.3 mm) H x 3.5" (63.5 mm) D
S
ingle gang electrical
b
ox—2" (51 mm) W x 3" (76 mm) H x 3.5" (63.5 mm) D*
* Dimen
s
ion
s
a
re
a
pproxim
a
te.