Step 1
To assemble the back piece:
Lay the back of the carrier flat on a hard surface with the logo facing down and
backwards. Position the back piece so the bottom is closest to you. Remove the
screws from two 11” perches and mount the two perches to the back piece (please
note, the perch can be mounted onto any side hole, this is personal preference).
Tighten the screws.
Using the hex nut driver and a Philips screw driver, install six clips onto the back
piece. The edge of the clips should be in line with the side edge of the back piece
(Fig 1-1).
Fig. 1-1
Step 2
To assemble the side doors:
Prepare the 2 doors by adding two corner clips to each door as imaged
(Fig 2.1).
Install the door jams on the inside of the carrier. The door jams go on the inside of
the carrier but are screwed on from the outside. Install the door knob onto each
door. Tighten the screw from the back of the door. Gentle screw in the two feeder
cups to the inside of the door.
(Fig 2.2).
Fig 2.1
Fig 2.2
Phoenix
Phoenix
