Step 3
To assemble the top, bottom, and side pieces:
While not necessary, it may be helpful to have a second person assist in holding
the pieces during this step.
Attach the top and bottom pieces by gently pressing the pegs into the plugs on the
back piece. Attach the right piece onto the back by gently pressing the pegs into
the plugs Attach the left-side piece. Make sure that all the pegs are secured into
their plugs.
Add the second set of screws and nuts to the bottom six corner clips. This will
secure the sides of the carrier to the back of the carrier (Fig 3-1).
Step 4
To assemble the front piece:
Using the hex nut driver and a Philips screw driver, install the last two clips onto the
front edge of the sides pieces. The edge of the clips should be in line with the
outside edge of the pieces.
Attach the top piece by gently pressing the pegs into the plugs on the front piece.
Take two screws and secure the two perches extending from the back piece into
place.
Add the second set of screws and nuts to the top six corner clips. This will secure
the sides of the carrier to the front of the carrier.
Fig. 3-1
