Page 10
If you ordered a Bachmann Shay kit to be used with a power source other than track power,
you do not need the battery, snapcap connector, or the blue jump wire. Your kit contains these
things in case you decide to switch to track power in the future. Before installation you must
remove the blue jump wire and the snapcap connector.
P1
1
2
3
4
5
6
7
8
P3
The Speaker
Your Bachmann Shay kit contains a 3-inch round speaker without mounting "ears."
The tender has a designated speaker opening, and the 3-inch round speaker fits
neatly in the designated space. As with all BIG SOUND™
model 96 and model 97 kits, the speaker is installed into
its own terminal marked P3 on
the sound board. Page 7 of
the full manual offers some
additional comments about the
speaker. There is no need to
drill holes in your Spectrum™
Shay for the speaker opening;
slots have been cut out for you.
Even though the Bachmann Shay kit speaker does not
have mounting "ears" with screw holes to secure it in place,
the speaker opening in the floor of the tender is fitted with
four screw-down clips. Loosen the screws, slide the speaker
basket under the clips, and tighten the screws.
Bring engine wires out here
so speaker will not cut into
insulation and short system
cut out slots
