Phoenix Mecano DewertOkin CU155, Installation Instructions Manual

Page: 3 / 16

General Information
These instructions are intended for the manufacturer of the end product and are not
designed for passing on to the operator of the end product. With regard to the specialist
information contained herein, these instructions can serve as a basis for drawing up the
instructions for the end products.
It is essential to note the information contained in these instructions! In doing so, you
can prevent mistakes being made in installing or connecting the system which could result
in…
Ÿ
injury and accidents as well as
Ÿ
damage to the drive system or the end product.
To supply the voltage, use only a DC power supply! DewertOkin
The DC power supply includes an earth-free electric circuit which is isolated DewertOkin
from the supply voltage via double or reinforced insulation.
DewertOkin accepts no liability for damage caused as a result of …
Ÿ
non-observance of these instructions,
Ÿ
alterations to the product not approved by DewertOkin or
Ÿ
the use of spare parts not manufactured or approved by DewertOkin - these may
not ensure adequate safety!
Due to the policy of ongoing product improvement, DewertOkin reserves the right to carry
out technical changes at any time without prior notification!
2
Contents
page
General Information...................................................................................................... 2
Designated Use............................................................................................................. 3
Prerequisites................................................................................................................. 3
Getting to Know the System......................................................................................... 4
Fitting............................................................................................................................ 6
Operation..................... ................................................................................................ 8
Maintenance and Repairs............................................................................................. 9
T 10 ype Label....................................................................................................................
Design of the CU155 Drive Control Unit....................................................................... 11
Troubleshooting............................................................................................................ 12
Cleaning and Care........................................................................................................ 13
Declarations of Conformity ........................................................................................... 14
1. Designated Use
The CU155 drive control unit is designed for installing in end products...
Ÿ
to control motorised adjustment devices in movable furniture components (e.g.
beds, chairs...)
The CU155 drive control unit is not intended for use …
Ÿ
in an environment where inflammable or explosive gases or vapours (e.g.
anaesthetics) are likely to occur,
Ÿ
in a damp environment, i.e. outdoors
Ÿ
in beds intended for cleaning in wash tunnels
Ÿ
in applications in which inadvertent movements are not prevented by appropriate
technical measures.
2. Prerequisites
The installation steps described in these instructions must be performed by a fully trained
electrical engineer .
Ÿ
This being the case, you should never carry out this work yourself unless you are a
qualified electrical engineer or
Ÿ
you should entrust this work to suitably qualified persons only.
Conformity according to EC Directives
The CU155 drive control unit is supplied ex factory as a machine not ready for use in
accordance with the EC "Machinery" Directive. In other words, you may not put the drive
control system into operation until you have met the
safety objectives of the "Machinery"
Directive and issued a corresponding Declaration of Conformity !
The drive control unit with DewertOkin DC power supply meets the safety objectives of the
EC Directives concerning
Low voltage and Electromagnetic Compatibility (EMC).
The CU155 drive control unit is not a medical product - for installing into same,
manufacture in conformity with the EC Directive for Medical Products or other regulations is
the responsibility of the manufacturer of the end product .
3
CU155
03/2020
ID 49623 3.0
03/2020
ID 49623 3.0