Phoenix Mecano Dewert Okin DUOMAT 9, Installation Instructions Manual

Page: 22 / 44

Installation DUOMAT 9
22 79338 4.0
6.2 Installation procedure
6.2.1 An example installation
Before installing the drive, make sure that you are observing all of the safety notices found in the
"Safety notices to observe during installation" section.
CAUTION
For the optional rechargeable battery: Disconnect the cable for the rechargeable bat-
tery from its socket before installing the DUOMAT 9.
Figure 12 Removing the motor cap
A Cover (optional) B Handholds C motor cap
CAUTION
Electrical components should be connected or disconnected only when the mains
power cord and the battery plug (when present) are unplugged.
1 Move your product into a position where it is supporting no load.
CAUTION
Be sure to carry out work on the drive in a position so that no loads are bearing on it.
Only in this way can you be sure to avoid any risks of crushing or injury.
2 Loosen the screws of the motor cap (C) and remove the motor cap from the DUOMAT 9 by pull-
ing firmly on the two handholds (B) .
3 Loosen the screws on the cover (shown by A in Figure 12) at the rear of the drive and remove
the cover.
B
B
A
C