Operating Notes
SG(AG) 300 control unit
24
75082(-)
7.
Operating Notes
The factual information contained within may be used when you are creating the end-product
manual. The installation instructions do not contain all information required for the safe opera-
tion of the end product. They only describe the assembly and operation of the SG(AG) 300
control unit as a partially assembled piece of machinery.
CAUTION
When creating the operating instructions, remember that the installation instructions
are intended for qualified specialists and are not for typical users of the end product.
7.1
General information
u
Only drives from DewertOkin should be connected to the SG(AG) 300 control unit since
they have already been verified to work together.
Delayed start-up
Follow the notice below when plugging the power plug into the power outlet:
NOTICE
There is a delay after the supply voltage is applied before the device actually turns
on. Wait at least 15 seconds before commissioning.
Power-on time / intermittent operations
The SG(AG) 300 control unit has been designed for intermittent operations. Intermittent opera-
tion is an operational mode where the drive must pause after a specified maximum period of
operation (power-on time). This protects the drive from overheating. In an extreme case, over-
heating can lead to a malfunction.
u
The type label on the drive specifies the maximum power-on time and the required pause
intervals.
Avoiding toggle operations
You should avoid switching from one direction of travel to the opposite direction without first
stopping the motor.
–
Make sure that you pause between motions! A pause (motor stop time)
can be activated using the controls.
NOTICE
You should always avoid a quick change ("toggle") of directions.
Summary of Contents for Dewert Okin AG 300
Page 2: ......
