Installation
SG(AG) 300 control unit
18
75082(-)
6.2.2
Electrical connection
CAUTION
Electrical components should be connected or disconnected only when the power
supply cord is unplugged.
NOTICE
There is a delay after the supply voltage is applied before the device actually turns
on. Wait at least 15 seconds before commissioning.
Routing the electrical cables
When routing the cables, be sure that:
the cables cannot get jammed,
no mechanical load (such as pulling, pushing or bending) will be put on the cables, and
the cables cannot be damaged in any way.
Fasten all cables (especially the connecting cables) to the end product using sufficient kink preven-
tion methods. Be sure that the design of the end product prevents the connecting cables from com-
ing into contact with the floor during transport.
Connecting the components to the SG(AG) 300 control unit
The electrical connection from the components e.g. drives, handset or locking-/ operating element
to the SG(AG) 300 control unit is made by plugging the plug into the SG(AG) 300 control unit.
Take off the shield cover (refer to page 20, figure 11) and plug the component plug into the proper
socket. Make sure that you use the proper connection position as specified in the connection layout
illustration (refer to page 10, figure 2).
Summary of Contents for Dewert Okin AG 300
Page 2: ......
