Phoenix Contact WP 04T, User Manual

Page: 9 / 60

Installation and Commissioning
8361_en_02 PHOENIX CONTACT
9
2 Installation and Commissioning
2.1 Unpacking the Device
Unpack all parts carefully and check the contents for any visible damage in transit. Also
check whether the shipment matches the specifications on your delivery note.
If you notice damages in transit or discrepancies, please contact Phoenix Contact immedi-
ately.
2.2 Mounting the Device
The device can be easily and quickly mounted from the rear of the device. A panel thickness
of 1 mm to 6 mm (0.039" to 0.236") is permitted for proper mounting.
1. Insert the device in the mounting cutout from the front.
Figure 2-1 Mounting the device using a mounting bracket
2. Insert the mounting brackets into the appropriate openings (figure 1) and pull the brack-
ets downwards until they lock in place (2).
3. Fasten the device into position using the threaded pins (3).
NOTICE: Damage
When installing the device, leave a gap of at least 30 mm (1.181") around the device to
ensure sufficient air circulation.
NOTICE: Damage
When the operating device is installed horizontally, please note that additional sources of
heat beneath the operating device may result in heat accumulation.
Make sure to allow sufficient heat dissipation!
Please observe the permissible temperature range specified in the technical data of the
user manual when operating the device.
NOTICE: Damage
In order to ensure the degree of protection specified in the technical data, always make
sure that the seal lies flat against the mounting surface and the threaded pins of the
mounting brackets are tightened uniformly to a maximum torque of 1 Nm.