Error Causes and Remedies
102786_C00_ia
PHOENIX CONTACT
5-3
Engli
s
h
5.2
Fault Scenario 2
Transport Error
The error is indicated by the adjacent display.
At the end of the cable or if there is a transport error, the cable cut stops and the display
shows the above message (red LED lights up):.
Remedy:
–
Check the cable infeed
–
Adjust application pressure of the drive rollers
–
Check / change drive rollers / measurement rollers
5.2.1
Check the Cable Infeed
•
Check whether a cable breakage / cable knot is preventing the infeed.
5.2.2
Application Pressure of the Drive Rollers Insufficient
Figure 5-2
Set application pressure
•
Switch off the CUTFOX 10 with the mains switch (press 0).
•
Pull out the mains plug (2).
•
Open the front door.
•
Set the application pressure with the adjustment screw (1):
Top position
→
weak
Bottom position
→
strong
•
Close the front door.
Auto Mode
TRANSPORT ERROR
WIRE END ?
ACKNOWLEDGE WITH ENTER
Risk of injury!
The front door must be opened. Pull out the mains plug, before opening the front door.
