Operating
102786_C00_ia
PHOENIX CONTACT
4-3
Engli
s
h
4.2
Cutting Cable Manually (Manual Mode)
4.2.1
Inserting a Cable
Bild 4-2
Inserting a cable
•
Switch off the CUTFOX 10 with the mains switch (press 0).
•
Pull out the mains plug.
•
Press the door opener (1).
•
Fold down the front door (2).
The rollers are raised (3).
•
Insert a cable between the rollers and pull it through the guide and out through the out-
let slot (4).
•
Fold up the front door (5). The rollers clamp the cable firmly (6).
•
Connect the mains plug.
4.2.2
Cutting a Cable
•
Switch on CUTFOX 10.
After switching on, the display
shows Auto Mode.
•
The display shows Manual Mode if the "mode" button is pressed 1 x.
•
Press the number key "6" until the required cable length is transported.
•
To cut off the cable, press the number key "2".
In Manual Mode there is no fault display "Transport error / Wire end ?".
In the event of the message "Cutting error", refer to the section 5.3 on page 5-5.
Risk of injury!
The front door must be opened. Pull out the mains plug, before opening the front door.
Manual Mode
LENGTH:
(6)
CUTTING:
(2)
