CUTFOX 10
4-4
PHOENIX CONTACT
102786_C00_ia
4.2.3
Stopping the Cable Cut
•
After the end of the cable cut, open the front door and remove the cable.
•
A new cut or another operating mode can then be run.
•
To put out of operation, switch off the mains switch (press 0).
4.3
Configuring the Cable Cut at the PC (PC Mode)
4.3.1
Connecting the CUTFOX 10 to a PC
Figure 4-3
Connection to a PC
•
Connect the PC to the RS-232 interface (1) via the RS-232 cable and, if necessary,
via the adapter from the accessories.
•
Project the cable cuts to the PC using the CD-ROM from the accessories.
4.3.2
Loading the Project From the PC to the CUTFOX 10
•
The display shows PC Mode if the "mode" button is pressed 2 x.
•
Select the Project No. and any data record, if required.
•
Enter the project number and – if applicable – the data record number ("D. REC") with
the number keys "0" to "9".
•
The remaining data is displayed automatically
.
PC Mode
PROJECT:
X
D.REC.:XX
QUANTITY:
XXX
GO TO: XXX
LENGTH:
XXXXX mm
XXXX mm2
„
Color
“
Displayed values can be overwritten or deleted with the "C" button. However, original
data remains unchanged in the PC. To restore the original data in the CUTFOX 10, it
must be transferred again from the PC.
