Removing hardware
107708_en_08
PHOENIX CONTACT
10.2
Removing cables
•
Disconnect the Axioline F station from the power supply.
The cables should only be removed from the supply connector if you wish to change the ter-
minal point assignment or no longer wish to use the supply connector.
•
Open the spring by pressing on the spring lever with a screwdriver (A in
•
Remove the cable (B in
).
Figure 10-2
Removing the cable
10.3
Removing the connector
Removing the supply
connector
•
Release the locking latch (A in
), tilt the connector upwards slightly (B in
), and remove it from the controller (C in
).
Figure 10-3
Removing the supply connector
Removing the Ethernet
connector
•
Release the RJ45 connector by pressing on the snap-in latch and remove the connec-
tor.
A
B
AXC F 1152 and AXC F 2152
AXC F 3152
X2
X1
SD
-C
ARD
R
X4
C
A
B
