The unit is in the operating mode, when
the power supply is switched on or at the
end of the setup.
One of the following will be displayed
6
Operation
326.81 The measuring signal has
been applied and lies within the
limits of the measuring range. The
display will show either the current
measured value, the MAX value or
the MIN value.
The input value is below the lower
limit of the measuring range. This
display alternates with the measu-
red value display.
The input value signal is higher
than the upper limit of the measu-
ring range. This display alternates
with the measured value display
The input value is below the
minimum permitted value.
The input value is higher than the
maximum permitted value.
Page 28
Page 29
english
Current measured value
MIN value (when activated)
MAX value (when activated)
Alarm 1 (when activated)
Alarm 2 (when activated)
6.1 Changing the Display during Operation
Pressing the P key once for 2 sec will
identify the function currently selected. If
within these 2 sec the P key is pressed
again, then the display will proceed to
the next display function. The new identi-
fication will be displayed for 2 sec to con-
firm this. After 2 sec the corresponding
value of the selected function will be dis-
played.
Pressing the
Key
Message
Display
LED Pr1 ein
LED Pr2 ein
1
1
1
2
2
1Following actuation the corresponding
value of the chosen function remains in
the display. During a PowerOff the func-
tion currently selected will be saved. At
the next PowerOn the corresponding
value of this function will be shown again
in the display.
2After 4 sec the display automatically
switches back to the current measured
value and the LED indicators Pr1 or Pr2
are turned off.
Note:
When an alarm value is shown in the dis-
play, its set value can be changed.
This can be prevented by disabling the
panel keys using the "Key" lock.