Phocos CMLup, User Manual

Page: 26 / 95

Normal operation Low voltage disconnect Overload or short-circuit of load
Red LED off Red LED on Red LED flashing
Low Voltage Disconnect Function
The controller has 2 different modes to protect the battery from being deeply discharged:
1. State of charge controlled: Disconnect at 11.4 V/22.8 V (at nominal load current)
up to 11.9 V/23.8 V (at no load current). Normal operation mode for safe battery
protection.
2. Voltage controlled: Disconnect at 11.0 V/22.0 V fixed setting. Appropriate if
bypass loads draw current directly from the battery.
The controller is preset to mode 1 from the factory. Changing the mode setting is described
below.
Settings
The controller can be configured for special operation. Three jumpers on the left side of the
controller enable the configuration of the following settings:
Jumper closed (jumper inserted) Jumper open (pulled jumper)
24
EN