Philips Vari-lite VL3015LT, Service Manual, Page: 53 / 184

M
AINTENANCE
P
ROCEDURES
: Z
OOM
O
PTICS
/ F
ROST
/ P
RISM
- C
ABLE
R
OUTING
R
EFERENCE
0 2 . 9 6 9 8 . 0 0 1 0 0 35
2
Zoom Optics / Frost / Prism - Cable Routing Reference
The photos and descriptions below show cable routing in and around the zoom optics, frost, and prism
assemblies. For additional information or assistance, please contact Vari-Lite Technical support.
This section contains information for:
• “Lens Group C Motor Cable” on page 35 (below)
• “Lens Group B Motor Cable” on page 35 (below)
• “Lens Group A Motor Cable” on page 36
• “Lens Group Motor Cables” on page 36
• “Frost Motor and Sensor Cables” on page 36
• “Prism Sensor Cable” on page 37
• “Frost Sensor Cable” on page 37
Lens Group C Motor Cable
Lens group C motor cable should run wire through cable tie saddle
installed low on carrier. It should be secured so cable goes out and away
from lens and cannot be caught during movement. It should run to
farthest forward cable tie saddle on mount. There should be slack to allow
free mechanism movement.
Lens Group B Motor Cable
The lens group B motor cable should have enough slack when group is
pushed all the way forward. It should be bundled with other wires and
mounted on carrier as shown.