Philips VARI-LITE 400 Series, User Manual

Page: 107 / 116

T
ROUBLESHOOTING AND
M
AINTENANCE
A
0 2 . 9 6 8 7 . 0 0 0 1 0 2 6 J u l y 2 0 1 1 89
Step 4. Grasp gobo carrier with fingers and gently pull gobo assembly straight up and out of rotating
gobo wheel. Note orientation of rotating gobo carrier assembly. New gobo assembly must
go in exactly the same.
Figure A-8: Removing / Installing Rotating Gobos
Step 5. At position where rotating gobo was removed, place replacement rotating gobo over open
slot (as shown in Figure A-9 ), slide into wheel, and gently snap gobo into place.
Figure A-9: Rotating Gobo Wheel - Gobo Installation.
Step 6. After rotating gobo is installed, reinstall rear head cover.
Rotating Gobo
Rotating Gobo
Carrier Orientation
Rear of gobo assembly. This
side (reflective side) towards
lamp. Note that gear is on front
of carrier.
Pull gobo straight up and
away from wheel assembly
Image on this side
Gear Side
(towards front of luminaire)
Open Position
(no gobo)
Note :
Assembly shown for clarity.
Rotating Gobo
Assembly
Front of Assembly Shown
(side towards front lens)