10
Preparing the remote control for
operation
The remote control and its batteries are packed separately in the
original DVD recorder packaging. You must install the batteries in the
remote control before use - described in the following section.
1
Take the remote control and the enclosed batteries (2 batteries).
2
Open the battery compartment, insert the batteries as shown and
then close the battery compartment. Match the polarities (+ and -)
on the batteries with the diagram on the remote.
The remote control is now ready to use.
Its range is approximately 5 to 10 meters.
'Aim' correctly
Aim the remote control at the DVD recorder and not at the TV set.
Connecting to the aerial
To receive TV programmes you have to connect the DVD-recorder to
the aerial or the cable network.
1
Switch off your TV set.
2
Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN
socket at the back of the DVD recorder.
3
Insert one end of the supplied aerial cable into the
TV
OUT
socket at the back of the DVD recorder and the other end
into the aerial input socket at the back of the TV set.
The aerial input socket of the TV set may be labeled ANT IN, RF
IN, 75 ohm, etc. Check your TV instructions for details.
Connecting the DVD recorder
