Philips PICO BARISTO AMF, Service Manual

Page: 18 / 58

PICO BARISTO 03 BRIEF INSTRUCTIONS
2/6
3.3. Troubleshooting
Remove the water tank from the
machine. Check the water tank
compartment to check if there are
any coffee beans on the bottom.
Remove them. Switch the machine
on and off.
Other error
codes
Switch the machine off and switch
it back on again after 30 seconds.
Try this 2 or 3 times.
Troubleshooting
Problem Cause Solution
The machine does not switch
on.
The machine is disconnected or
the main switch is in the OFF
position.
Check if the mains cord is
inserted correctly.
Make sure that the main switch
is set in ON position.
The machine is in DEMO mode. The standby button has been
pressed for more than 8
seconds.
Switch the machine off and then
on again using the main switch
on the back of the machine.
The drip tray is quickly filled. This is normal. The machine
uses water to rinse the internal
circuit and brew group. Some
water flows through the internal
system directly into the drip
tray.
Empty the drip tray when the
‘drip tray full’ full indicator pops
up through the drip tray cover.
Place a cup under the dispensing
spout to collect rinsing water.
The coffee grounds container
full icon remains displayed.
The coffee grounds container
was emptied while the machine
was switched off.
Always empty the coffee
grounds container while the
machine is ON. If the coffee
grounds container is emptied
while the machine is switched
off, the coffee cycle counter
is not reset. In that case,
the ‘empty coffee grounds
container’ message will stay
on the display even though the
container is not full.
The coffee grounds container
was placed back too fast.
Do not place back the coffee
grounds container until the
screen message prompts you
to put it back.