2.3
Assigning IP address and Starting Configuration
To enable access to the NetCam DVR, first you have to assign an appropriate IP.
Terminology
■
IP Address: Acquire IP address from network administrator.
■
MAC Address: The 12digit number on the label at the bottom of NetCam
DVR.
■
Direct Cable: A common UTP cable to connect devices such as a PC or
NetCam DVR that has an Ethernet port (RJ-45 port).
■
Crossover Cable: A specially designed UTP cable to connect two devices
directly like connecting a PC and NetCam DVR through Ethernet port.
2.3.1
IP Address
Important
■
You must use a new assigned IP address, do not use the default or example
IP address.
■
It is highly recommended to assign an IP address before you connect the
NetCam DVR, otherwise conflicts may occur.
There are two methods to assign IP address to the NetCam DVR:
■
With setup program
■
With ARP command
Connecting with a Crossover Cable to assign an IP address
■
When you assign an IP address to the NetCam DVR, it is recommended to
connect the NetCam DVR and a PC with a crossover cable that is provided
with the NetCam DVR.
■
You may use a direct cable (UTP cable). In this case you should use a HUB
to connect the NetCam DVR and a PC to assign an IP address. Or you
should have a LAN cable to connect the NetCam DVR, and a PC that is
already connected with a LAN cable.
14
NetCam DVR
Section 2
DVR_NC_ii_98911_0047.qxd 12/13/00 1:53 PM Page 14
