Overview
4-2
Troubleshooting
Radio Test
If the
data/holding results
light does not come on after you take a
measurement, another step that can be taken is to perform a Radio Test.
The
Radio Test
makes sure that your measurements are being properly
sent from the measurement device to the Home Hub/TeleStation. The
RADIO TEST
button, {
or
}, is on the front of the device.
To perform the Radio Test, follow these steps:
Step 1.
1. Press and hold down the
RADIO TEST
button on the
measurement device for
3 to 5 seconds
or until the Home Hub/
TeleStation starts beeping.
Note
If the
using phone
light on the Home Hub/TeleStation lights, stop and
wait until it turns off before performing the Radio Test.
The following messages will appear on the indicated device.
The
Scale
and
Pulse Oximeter
will display
rF
.
The
Rhythm Strip Recorder’s
RELAX
light will flash once per
second.
The
Home Hub/TeleStation
should beep:
If the Home Hub/TeleStation does not beep, do the following:
– Make sure the measurement device has fresh batteries
– see if there are any large objects between the measurement
device and the Home Hub/TeleStation.
If there are large objects, move the measurement device to a
different location.
If there are no large objects, move the measurement device
closer to the Home Hub/TeleStation.
– Make sure there are no cordless or cellular telephones or
computers in use near the Home Hub/TeleStation.
– Repeat the Radio Test
If the Radio Test is still not successful, refer to the following
Troubleshooting tables to try to further resolve the problem
T
All manuals and user guides at all-guides.com