Device Usage
2-44
Philips Telemonitoring Set
Procedure for M3814B Pulse Oximeter
The following steps describe how to use the
M3814B
Pulse Oximeter to
measure your blood oxygen level (%SpO
2
) and pulse rate. By default,
pulse rate is turned off. To turn pulse on, press and hold both the
START/STOP
and
test
buttons
for more than 3 seconds.
Repeating this step will
turn the pulse rate display off again.
Step 1.
Sit
within 20 ft.
of the Home Hub or TeleStation with your hand
resting on a flat surface and the Pulse Oximeter in front of you.
Step 2.
Open the sensor and fully insert
your finger (index, middle, or ring,
but not your thumb) until the end of
your finger reaches the finger stop.
The cable should extend
over
your
finger toward your wrist as shown
in the figure.
Step 3.
Sit comfortably with your hand resting on the surface so that it
can remain still. Press the
START/STOP
button and
hold your
hand still
during the measurement
.
Press
Hold hand still
START/STOP
button
All manuals and user guides at all-guides.com