Philips HS8460, User Manual

Page: 14 / 358

Problem Possible cause Solution
You have not put the
shaving heads back into
their original holders.
One of the shaving
heads does not have a
shaving conditioner hole
in its centre and needs
to be placed in a
speciic holder.
Make sure you put the shaving head without
conditioner hole in the correct holder. This is the
holder that is closest to the on/off button when
the shaving unit is assembled on the shaver.
No shaving
conditioner
comes out of the
holes when I
press the shaving
conditioner
button.
The shaving cartridge is
almost empty.
Reill the shaving conditioner cartridge (see
chapter ‘Preparing for use’).
The trimmer
makes more
noise than other
trimmers.
This trimmer has an
open design.
Due to the new open design, you hear the cutting
action of the trimmer more clearly than is the case
with other trimmers. This is normal and does not
mean that there is something wrong with the
trimmer.
Extra-thorough cleaning method
Make sure the appliance is switched off.
1 Pull the shaving unit off the shaver (Fig. 31).
2 Turn the guard clockwise and lift it from the shaving unit (Fig. 32).
Note: Only remove one shaving head at a time. This ensures that you always put the shaving head back
into its original holder, which is necessary because two of the shaving heads have special holes for the
shaving conditioner. This also ensures that you do not mix up the cutters and guards of different shaving
heads, which affects the shaving performance.
3 If necessary, remove the cutter from the guard.
4 Clean the cutter and guard with the brush supplied.
5 After cleaning, place the cutter back into the shaving unit with the cutter legs
pointing upwards.
6 Place the guard back onto the shaving head holder (over the cutter) (Fig. 33).
7 Turn the guard anticlockwise until it locks into position (Fig. 34).
8 Put the shaving unit back onto the shaver (‘click’) (Fig. 35).
EngliSH
14