Philips HD9255, User Manual

Page: 25 / 180

25 ENGLISH
Problem Possible cause Solution
I see some peeling
off spots inside my
Airfryer.
Some small spots can
appear inside the pan of
the Airfryer due to the
incidental touching or
scratching of the coating
(e.g. during cleaning with
harsh cleaning tools and/
or while inserting the
basket).
You can prevent damage by lowering the
basket into the pan properly. If you insert
the basket at an angle, its side may knock
against the wall of the pan, causing small
pieces of coating to chip off. If this occurs,
please be informed that this is not harmful
as all materials used are food-safe.
White smoke
comes out of the
appliance.
You are cooking fatty
ingredients.
Carefully pour off any excess oil or fat from
the pan and then continue cooking.
The pan still contains
greasy residues from
previous use.
White smoke is caused by greasy residues
heating up in the pan. Always clean the
pan and the basket thoroughly after every
use.
Breading or coating did
not adhere properly to
the food.
Tiny pieces of airborne breading can cause
white smoke. Firmly press breading or
coating to food to ensure it sticks.
Marinade, liquid or meat
juices are splattering
in the rendered fat or
grease.
Pat food dry before placing it in the basket.
The screen on the
Airfryer shows “E1”.
The device is broken/
defect.
Call the Philips service hot line or contact
the Consumer Care Center in your country.
Your Airfryer might be
stored in a place where it
is too cold.
If your device was stored at a low ambient
temperature, let it warm up to room
temperature for at least 15 minutes before
you plug it in again.
If your display still shows “E1”, call the
Philips service hot line or contact the
Consumer Care Center in your country.
The WiFi LED on
my Airfryer is not
shining anymore.
•
The Airfryer is not
connected to your
home WiFi anymore.
•
You have changed your
home WiFi network.
Repeat the pairing process in the order
described in the app. If it doesn't help, start
the setup process again.
The App shows that
the pairing process
is not successful.
Check whether you have
done the steps in the order
that is described in the
app: First push the button
on the appliance, then
activate pairing in the app.
Repeat the pairing process in the order
described in the app. If it doesn't help, start
the setup process again.
My display shows
blinking “---”.
Your Airfryer is updating
the firmware.
Wait for about one minute before the
firmware update process is finished.
You cannot use the Airfryer during the
firmware update.