Philips HB566, User Manual

Page: 9 / 96

Possible causes/solutions
The plug has not been properly inserted into the wall socket.
There may be a power failure. Check if the power supply works by connecting another appliance.
You have not set the time.
Perhaps you forgot to switch the facial tanner on.
The lamp of the facial tanner (HB568 only) is still too hot to go on. Allow the lamp to cool down for
approx. 3 minutes.
Check the fuse of the circuit to which the tanning appliance has been connected.The correct fuse type
is a 16A standard fuse (in the UK a 13A fuse for HB567) or a slow-blow automatic fuse.
You are using an extension cord which is too long or does not have the correct current rating. Consult
your dealer. Our general advice is not to use an extension cord.
You are not following the tanning schedule suitable for your skin type. Check the table in 'Tanning
sessions: how often and how long?'.
The distance between your body and the canopy is larger than 20 cm.
When the lamps have been used for a long time, the UV light emitted will decrease.This effect only
becomes noticeable after several years.You can solve this problem by selecting a slightly longer tanning
time or by replacing the lamps.
Read the last part of the section 'Natural fragrances' in the chapter 'Using the appliance'.
Problem
The appliance does not start.
The facial tanner does not start.
The fuse cuts off the power when the appliance is
switched on or during use.
Poor tanning result.
Not enough fragrance.
Troubleshooting
If the appliance has not been installed or is not used in accordance with the instructions, it may fail to work properly. In that case you will be able to solve the
problem yourself by following the troubleshooting tips below.
If the problem is not mentioned in the list, the appliance may not work properly because it has a defect. In that case we advise you to contact your dealer or an
authorised Philips service centre.
ENGLISH 9