eW Burst Powercore Product Guide
23
8. If installing in a damp or wet location, seal all junction boxes and mounting
accessories with contractor-grade RTV silicone sealant. Use gaskets, clamps, and
other parts and fittings required to comply with local outdoor wiring codes.
9. If installing in parallel, connect the wires from each fixture to the lead wire from
the line power source in the common junction box.
10. Connect the wire from the first fixture in the series to the line power source if
installing in series, or from the common junction box to the line power source if
installing in parallel.
Attach Safety Cable
(optional)
When installing eW Burst Powercore fixtures to a wall or overhead, use a safety
cable to tether it to a secure anchor point. When dictated by local or state code or
advised by a structural engineer, attach a safety cable to the eW Burst Powercore
fixture housing and tether it to a secure anchor point.
1. Thread a safety cable through the fixture housing as shown.
2. Attach the safety cable to the mounting surface using a method that follows the
code or engineer’s requirements.
1234 567 89101
123-456789-00
111000 22b342-45/567
123-4567 8 91 01
0000000000
12345678
00
0000
Architectural
Landscape
Safety cable minimum requirements
Material
304 or 316 Stainless Steel
Size
5/32 in (4 mm) nominal diameter
Minimum break load must be greater
than 2,400 lb (1089 kg)
RTV Silicone
RTV Silicone
RTV Silicone
RTV Silicone
RTV Silicone
RTV Silicone