DAY TO DAY OPERATION
19
7.15 On screen indication of Radio mode
The still picture shown opposite signals the radio mode.
7.16 On screen indication of Loss of
signal
The still picture shown opposite indicates a Loss of signal
at receivers aerial input.
7.17 If your receiver is in Standby or
Low power mode and the right-
hand, red LED is blinking
This indicates that a free over-the-air upgrade of your
receiver is taking place. Do not interrupt this operation.
Wait until the blinking LED stops and the left hand LED is
either orange or red (signalling either standby mode or
low power mode). You can then continue with normal
operation.
7.18 How do I reset my receiver if it
freezes?
In the unlikely event that your receiver freezes (i.e. you
can no longer control it with the remote control), simply
proceed with the steps described below:
- Press the LOW POWER button, on the receiver
front panel for at least 5 seconds. After releasing the
button wait for a stable front display indication (i.e. the
left LED is either orange for standby mode or green for
TV mode). You can now continue with normal
operation.
English
