DPM 9450 - User Manual
32
3. Press the DL/
VC
button and say:
zero
. This starts the training process again and deletes the current training
result.
4. Repeat the new command.
Additional information
•
To delete the training result for a character or phrase, press the DEL (Delete) button for 0.5 seconds. If a
character or phrase has not been trained, pressing the DEL button for 0.5 seconds exits the training menu.
•
To exit training, press the Jog Dial briefly. Select the menu entry for exiting the DPM menu (
) and confirm
the selection by pressing the Jog Dial again. You can exit training at any time. The only exception is when you
have already started training; you cannot exit between the first and second training.
Deleting all training results
If you want to revert the status of all trained characters or phrases to untrained, do the following:
1. Access the DPM menu, go to the menu entry for voice command training and press the Jog Dial to access it.
2. Press the DEL (Delete) button for about two seconds until this screen appears:
Note:
At this stage, you can cancel the deletion process by pressing any DPM button or moving the 4-Position
Switch.
3. Press the DEL button again for about two seconds. When all training results are deleted, this screen appears:
Recognition
Recognition is the state where the DPM expects Keyword input via voice commands, interprets the commands
and subsequently delivers the recognition result on the display. Depending on the type of voice command you are
using, the result can either be a character that you have spelled (alphanumeric recognition) or a phrase (Keyword
recognition).
Alphanumeric recognition
In alphanumeric recognition mode you can spell letters, numbers and special characters. You can only use those
numbers, letters and special characters for spelling which you have previously trained.
DPM 9450 supports alphanumeric commands for up to five Keywords. If more than one Keyword is enabled for
alphanumeric commands in
SpeechExec Dictate
, the Keyword input becomes mandatory. This means that when
you create a new dictation, you are immediately prompted to provide the Keyword input via alphanumeric
commands. If only one Keyword has been enabled, you can provide the Keyword input at any time during
dictation. Proceed as follows:
1. Make sure your dictation is in Stop mode; on DPM 9450/00 this can also be Record Standby mode. This first
step is valid in the case of one Keyword enabled for voice commands only.
2. Press the DL/
VC
button to enter recognition mode. Keep the button pressed while you use voice commands.
The DPM displays the predefined Keyword usage (in this example:
IDENT-#
) and you can start spelling. For
example, say:
one
.
Summary of Contents for DPM 9450
Page 1: ...DPM 9450 User Manual ...
