Philips BDL4785SL/00, Service Manual

Page: 109 / 141

109 BDL5585XL LCD
General Product Specification
7.6 Resins
x
RoHS requirements.
x
WEEE requirements.
x
PC+ABS
x
China Rohs required. ( sales in China only)
7.7 Paint Used
x
RoHS requirements.
x
WEEE requirements.
7.8 Plastic Mold Tooling
x
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush, weld
lines, gate marks, ejector marks, etc.).
x
Painting to cover up cosmetic defects due to molding is strongly discouraged.
No plastic mold tooling
7.9 Plastics Flammability
x
All Plastics to be Flame Retardant UL 94-V0 or Better (if Display weighs less than 18kg; UL94-V0 is
OK).
x
Base / Pedestal to be Flame Retardant UL 94-HB.
x
All major plastic parts (bezel, back cover, base) need to be molded from same resin. Base / Pedestal
otherwise specified.
No plastic parts
7.10 Texture/Glossing of Housing
x
The texture area and texture no should follow Philips make-up sheet.
x
The exterior surfaces shall have a uniform texture.
x
Philips must approve the mold texturing.
x
Detail document for texture refer to UN-D249.
x
The gloss value of texture area < = 20 gloss units.
No plastic parts
7.11 Base Tilt / Swivel Range
x
Tilt - N.A. (per commercial spec request)
x
Swivel Range - 0°
x
Base detach - Should be directly disassembled from main body, so as for easy
install the Display to wall mount.
x
Tip over - 15° minimum in worst case, base dimension designed so that ID
and tip over requirements can be met.