Creating a Vision.net Touchscreen
11
Vision.net Touchscreens
Installation & User’s Manual
Note:
"-xxx" is the last three digits of the unit’s IP address. * = Old hardware. Old Hardware designations are
included for service and support issues. These must not be used in new installations.
c. Tap X to close window.
Step 13. Close all open windows.
Step 14. Open the
START
menu.
Step 15. Select
SETTINGS/NETWORK AND DIALUP CONNECTIONS
. This will open the Network
settings window.
a. Tap and hold on any wireless connection for 3 seconds.
b. From menu select
DISABLE
.
c. Tap
X
to close window.
Step 16. Open the START menu.
Step 17. Select
SETTINGS/TASKBAR AND START MENU
. This will open the Taskbar settings window.
a. Check the box to
AUTOHIDE
.
b. Uncheck the box for
ALWAYS ON TOP
.
c. Tap
X
to close window.
Step 18. Close all windows.
Step 19. Open
MYDEVICE/HARDDISK
.
Step 20. Double tap on
STARTUP FOR SHASTA
. This will launch the Shasta environment.
Note:
The USB key must be in place.
Step 21. Select
UPDATE FIRMWARE AND LAUNCH APPLICATION
. At this point, the touchscreen will
copy all necessary files from the USB key.
WARNING!
Do not remove the USB key until the transfer is complete.
The Touchscreen is now ready for use.
Note:
Depending on what
ActiveScreen.ntc2
file was present in the
UPDATE
folder on the USB key the screen
may display incorrectly. Please be sure that the file on the USB key is for the desired screen.
Touchscreen Type
Device Name
Portable
TS-P-xxx
7
(non-Aaeon)
& 10 Inch
TS-I-xxx
3.5 Inch
TS-D-xxx
15 Inch
(iEi only)
TS-C-xxx
15 Inch
(Aaeon only)
TS-B*-xxx
7 Inch
(Aaeon only)
TS-A*-xxx
Table 3: Touchscreen Device Names
